雨水混流泵供应价产品介绍「多图」

混流泵

3.

installation base:the soil texture should be firm&solid.

 4.

during installation, keep the pump axile in horizontal p ition.

 5.the end of

water inlet pipe should be immersed under water in about one meter&far away

from the end of mud in about half meter.

 6.after installing the pump,calculate the

suitable suction ht=&head.under the stable water level condition,

开车顺序：

    1、关闭出口闸阀

    2、将水注入水泵，以排除进水管及泵内空气，可从泵体顶端引水杯注入清水，也可用真空泵注水开动真空泵，排除水泵及管内气体在水充满水泵的同时，起动水泵，打开闸阀，停止真空泵。

3、开启电动机注意水泵的旋转方向。

    4、当电动机正常运转后，逐步开大闸阀，达到所要求的工况后，调节填料松紧。若水泵运转，轴承温度等都正常，则可继续运行。

iii.  starting

sequence

   1.close the oulet

sluice valve.

   2. inject

water into pump to remove the air in water-in pipe&pump which can realized

by injecting clear water from the water diversion cup of the pump body end or

by vacuum pump(start the vacuum pump, remove the air from pump&pipes, start

the water pump when the pump is full of water, open the sluice valve, stop the

vacuum pump).

   3. start the

motor(pay more attention on the rotation direction of pump)

   4. when the motor runs normally, turn up the

sluice valve gradually, adjust the tightness of padding when gettng to the

required working condition.if the pump runs well, the temperature of bearing is

normal,&it can run sequentially.

 6、轴承-

 the bearing is

 hot

 1、润滑油脂不足

 2、润滑油不好或不清洁

 3、轴心没有对准

 4、轴承松动或磨损

 5、皮带太紧

 1.lubricating grease is not enough

 2.the quality of lubricating oil is not

 good/dirty

 3.the axes is not aiming

 4.the bearing is loose/attrition

 5.the belt is too tight.

 1、加油

 2、清洗轴承

 3、找正

 4、修正

 5、适当放松

 1.add lubrication oil

 2.wash

 the bearing

 3.aligning

 4.amending

 5.loosen it properly

4、水泵使用后一定要注意保养，比如说当水泵用完后要把水泵里的水放干净， 是能把水管卸下来然后用清水冲洗。

5、水泵上的胶带也要卸下来，然后用水冲洗干净后在光照处晾干，不要把胶带放在阴暗潮湿的地方。水泵的胶带一定不能沾上油污，更不要在胶带上涂一些带粘性的东西。

6、要仔细检查叶轮上是否有裂痕，叶轮固定在轴承上是否有松动，如果有出现裂缝和松动的现象要及时维修，如果水泵叶轮上面有泥土的也要清理干净